8/11/2023 0 Comments Anchoring metal swing set![]() You can attach your anchors to your set’s legs when you’ve determined that your anchors are in the correct spots. You want them to be in line with the legs and in roughly the same location on each leg. If you were unable to move your set, skip to the next step.ĭouble-check that the anchors are in the proper places in relation to your swing set’s legs. Once you have all four anchors in place, you can move your swing set back into position. You’ll want to leave the anchor head out of the ground only enough to secure it to the leg with your chain, wire, or bracket in the proper place. However, if you don’t have room to twist the anchors into the ground straight since you’re unable to move your set, a slight angle is acceptable. ![]() If possible, it’s best to install the anchor perpendicular to the ground surface so the anchor head stands straight when installation is complete. If not, you can use a small metal bar or a screwdriver through the anchor head to help twist the anchor into the ground. If you’re able to attach a drill to your anchors safely, it’s probably the quickest and easiest way to twist them into the earth. Note: If your playset is too big to move, you can attempt to twist the anchors in without moving it, although this may be difficult so close to the structure.Īs a workaround, you can move the anchors away a few inches, but you’ll have to increase the length of the fastening chain or wire you use to secure the legs to the anchors. Once you have the stakes in place, it’s time to move the set out of the way. If you’re anchoring a playset that has straight instead of slanted legs, you’ll want to place the stakes on the inside as well, to help ensure they won’t be a tripping hazard. The stakes should be placed inside the A that the legs make on each side, no more than a few inches away. Step 1: Mark The Groundĭo this by hammering your plastic or wooden stakes into the ground on the inside of the swing set legs. It’s best to avoid anchors that require you to drill holes in your legs if you have a metal swing set. These anchors come with wire or chain attachments and a bracket around the swing set leg.įor these to work properly, you simply have to know if the bracket will fit all the way around the leg. The easiest twist-in ground anchors for both wood and metal sets require no drilling into the legs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |